PDF《Titl》

2009 ? Updated Power on page

31 November

2008 ? The SP_IO_SPEED default value was updated in Table

3 on page

13 ? The Moisture Sensitivity was improved from four to three in Package Characteristics on page

24 July

2008 ? Updated Recommended Operating Conditions on page

30 ? Updated Power on page

31 April

2008 ? Information on Register Requirements Using

125 MHz S_CLK for a 3.125 Gbps Link Rate on page

72 was added to Clocking on page

71 and the supporting information was added to EEPROM Scripts. November

2007 ? Information on P_CLK Programming on page

75 was added to Clocking on page 71. ? General clarification in Signals and Package on page 9, including: ― Any unused signal that is designated a No Connect (N/C) must be left unconnected ― The I2C_SCLK signal description was updated ― The BCE signal description was updated

8 Tsi578 Hardware Manual April 4,

2016 Integrated Device Technology www.idt.com

9 Tsi578 Hardware Manual April 4,

2016 Integrated Device Technology www.idt.com 1. Signals and Package This chapter describes the packaging (mechanical) features for the Tsi578. It includes the following information: ? Pinlist on page

9 ? Signals on page

10 ? Package Characteristics on page

24 ? Thermal Characteristics on page

26 1.1 Pinlist The pinlist and ballmap information for the Tsi578 are available by visiting www.idt.com. For more information, see the following documents: ? Tsi578 Pinlist ? Tsi578 Ballmap

10 Tsi578 Hardware Manual April 4,

2016 Integrated Device Technology www.idt.com 1.2 Signals Figure 1: Signal Groupings SP2 SP4 SP6 SP8 SP_IO_SPEED[1:0] Ports 0,1 Ports

2 -

13 1

1 1

1 1

1 1 JTAG TAP I2 C TCK TDI TDO TMS TRST_b I2C_SCLK I2C_SD

1 1 HARD_RST_b SW_RST_b

1 INT_b Reset

2 RefClks S_CLK_[p,n]

1 P_CLK VSS VDD Logic Pwr/Gnd VSS_IO Port Config

2 Interrupt VDD_IO IO Pwr/Gnd SP0, 2,

4 ….

14 VDD

1 I2C_DISABLE SP10 SP12 SP14_T[A,B,C,D]_[p,n]

8 Ports 14,15 SP_VDD SP0_T[A,B,C,D]_[p,n] SP0_R[A,B,C,D]_[p,n] SP0_REXT

8 8 SP0_MODESEL

1 1 SP1_PWRDN

1 SP0_AVDD

1 SP14_R[A,B,C,D]_[p,n] SP14_REXT

8 SP14_MODESEL SP14_PWRDN

1 1

1 SP15_PWRDN

1 SP14_AVDD

1 1 BCE

1 MCES Multicast

1 REF_AVDD

11 Tsi578 Hardware Manual April 4,

2016 Integrated Device Technology www.idt.com 1.2.1 Conventions The following conventions are used in the signal description table: ? Signals with the suffix _p are the positive half of a differential pair. ? Signals with the suffix _n are the negative half of a differential pair. ? Signals with the s........