PDF《TPF110/TPF110U/TPF110L》

300 mW VIN 输入电压 VDD + 0.3V to GND - 0.3V IOUT 连续输出电流

65 mA TJ 最大结点温度,任何环境

150 ° C TA 供电时的环境温度范围 C45 to

85 ° C TSTG 存储温度范围 C65 to

150 ° C TL 引线温度范围 (Soldering

10 sec)

300 ° C θJA 6-Lead SC70 耐热性

430 ° C/W (1) This data was taken with the JEDEC low effective thermal conductivity test board. (2) This data was taken with the JEDEC standard multilayer test boards. * 注意: 如果器件运行条件超过上述各项绝对最大额定值,可能对器件造成永久性损坏.上述参数仅是允许条件的极大值,我们 不建议使器件运行在该条件下或在技术规范以外的条件下运行.这只是强调的额定值,不涉及器件在这些或任何其他条件下超出本 技术规格指标的功能性操作.长期在绝对最大额定值条件下工作会影响器件的可靠性. 静电放电保护 (ESD, Electrostatic Discharge Protection) Symbol Parameter Condition Minimum Level Unit HBM Human Body Model ESD MIL-STD-883H Method 3015.8

8 kV CDM Charged Device Model ESD JEDEC-EIA/JESD22-C101E

2 kV TPF110/TPF110U/TPF110L Ultra-low Power Video Filter with Shut-down &

SAG Correction REV1.5 www.3peakic.com ~

3 ~ ?

2011 3PEAK INCORPORATED 电气特性 除非另有说明,否则 VDD = 3.3V,TA = +25° C,RL = 150Ω 至GND. 符号 参数说明 测试条件 最小值 典型值 最大值 单位 输入电气特性 VDD 电源电压范围 2.85 5.5 V IDD(ON) 静态供电电流(IQ) (1) TPF110: VDD=3.3V, VIN=500mV, EN=VDD, no load 3.9 4.9 mA TPF110: VDD=5.0V, VIN=500mV, EN=VDD, no load 5.1 6.3 mA TPF110L: VDD=3.3V, VIN=500mV, EN=VDD, no load 1.9 2.8 mA TPF110L: VDD=5.0V, VIN=500mV, EN=VDD, no load 2.9 3.9 mA IDD(OFF) 关断供电电流 VDD=3.3V, EN=0 0.5 1.5 μA VDD=5.0V, EN=0 1.5

3 μA VOLS Output Level Shift Voltage VIN = 0V, no load, input referred

53 80

124 mV VCLAMP Input Voltage Clamp IIN = -100?A -40

0 +40 mV ICLAMP-CHG Clamp Charge Current VIN = VCLAMP - 200mV -1.5 -1.7 mA ICLAMP-DCHG Clamp Discharge Current VIN = 500mV 1.5 2.0 5.1 μA RIN 输入阻抗 0.5V <

VIN <

1.0V 0.5

3 MΩ AV 电压增益 VIN=0.5V, 1V and 2V RL = 150Ω to GND 5.9 6.01 6.025 dB ASAG SAG 校正 DC Gain to VOUT SAG open 2.25 V/V PSRR 直流电源电压抑制比 ΔVDD = 3.3V to 3.6V

61 dB ΔVDD = 5.0V to 5.5V, 50Hz, VIN=0.7V

67 dB VOH Output Voltage High Swing VIN = 3V, RL = 150Ω to GND 3.18 V VOL Output Voltage Low Swing VIN = -0.3V, RL =75Ω 0.05 V ISC 输出短路电流 VIN =2V, output to GND through 10Ω

65 mA VIN=100mV, output short to VDD

65 mA VIL 禁用阈值 VDD = 3.0V to 5.5V 0.8 V VIH 使能阈值 VDD = 3.0V to 5.5V 1.6 V ROUT 关断输出阻抗 EN = 0V DC

12 kΩ EN = 0V, f = 4.5MHz 5.8 kΩ Note: (1). 100% tested at TA=25° C. TPF110/TPF110U/TPF110L Ultra-low Power Video Filter with Shut-down &

SAG Correction REV 1.5 ?

2011 3PEAK INCORPORATED ~

4 ~ www.3peakic.com 符号 参数说明 测试条件 最小值 典型值 最大值 单位 交流电气特性 f-1dB -1dB 带宽(2) RL=150Ω 7.6 8.2 9.1 MHz f-3dB -3dB 带宽(2) RL=150Ω 7.8

9 10.5 MHz Att27MHz Stop BandAttenuation (2) f = 27MHz 38.2 57.2 73.6 dB SR Slew Rate 2V output step, 80% to 20%

38 V/μs dG 微分增益 Video input range 1V 0.4 1.2 % dP 微分相位 Video input range 1V 0.7 1.5 ° THD 总谐波失真 TPF110: f=1MHz, VOUT=1.4VPP 0.03 0.1 0.2 % TPF110L: f=1MHz, VOUT=1.4VPP 0.2 % D/DT Group Delay Variation f = 100kHz, 5MHz 5.4 ns tPD Propagation Delay Maximum delay from input to output: 100kHz to 4.43MHz